-----------------------------------

Emil

29 Ian 2011 19:22



-----------------------------------

PHD 1.12.3 
This pre-relese (1.12.3 on Windows only) includes:
- (1.12.3) Allowed ranges on parameters in graph log and advanced dialog synced.
- (1.12.3) Support for "late bound" ASCOM cameras ("ASCOM (late) camera" in menu). This will allow in v4 and v6+ ASCOM cameras and any v5 cameras that did not support the (now defunct) "early binding" mode.
- (1.12.3) Support for "subframe" mode on late-bound ASCOM cameras
- (1.12.3) Last-used ASCOM camera now remembered in ASCOM Chooser dialog

- (1.12.2a) Mac-only fix to >1 Starlight Xpress camera
- (1.12.2) Tweak to Star Mass tolerance. Hopefully, it's less prone to rejecting things now. You can disable it entirely (promise!) by setting it to 1.0. Also, it will only reject two frames in a row because of this.
- (1.12.2) Calibration portion of log file cleaned up to put commas between values for easier analysis
- (1.12.2) If entering calibration data manually, current value will be pre-filled in dialog
- (1.12.1) Log file changed: Another column has been added to list what kind of fault PHD might have found with a star during guiding. 0=OK, 1=saturated (but still trying to work with it), 2=Low SNR, 3=Low star mass, 4=High change in star mass, 5=Large motion detected. Anything above 1 causes PHD to sit still and not move.
- (1.12.1) "Max RA Duration" parameter added to Advanced menu(default is 1000 ms). Can be used to cap the RA duration during guiding.
- (1.12.1) Flip RA data entry added to Tools menu to flip the vectors post meridian-flip
- (1.12.1) "Star mass tolerance" added to Advanced menu (default is 0.3). If the change in mass from one time to another exceeds this fraction, the current sample is rejected and not used for guiding. So, if the star mass on one sample is 10000 and the next it is 12000, the command is sent. If the next is 14000 (or 6000) it isn't (with the threshold set at 0.3 -- if it were at 0.4, these would be sent).
- (1.12.1) Reworked Advanced dialog
If you're running an Orion autoguider and you've not upgraded their drivers for some time (you're not on 1.12 already) and things don't work - upgrade their drivers from their site.